Precautions for using Flue Gas Sulfur Dioxide Removal Catalyst

1. The newly prepared Flue Gas Sulfur Dioxide Removal Catalyst solution should not be added to the sulfur foam layer, but should be added to the clear liquid to reduce the loss of sulfur foam.

2. Don't add too much at once, it is best to add evenly in each shift to prevent excessive fluctuations in concentration, resulting in unstable desulfurization efficiency.
3. After adding, it is necessary to strengthen the observation and analysis of the changes in the inlet and outlet H2S concentration, adjust the amount of desulfurization absorbent and Flue Gas Sulfur Dioxide Removal Catalyst according to the analysis results, and keep the outlet H2S within the process indicators.
4. If before using Flue Gas Sulfur Dioxide Removal Catalyst, the equipment and pipeline have serious sulfur accumulation. It should be added slowly to prevent a large amount of accumulated sulfur from loosening in a short time, resulting in suspended sulfur capacity and affecting desulfurization efficiency. Generally, other desulfurization methods are used instead of Flue Gas Sulfur Dioxide Removal Catalyst. In the initial stage, the sulfur recovery volume will increase, but after a while After time, it returned to normal.
5. The packaging bag of Flue Gas Sulfur Dioxide Removal Catalyst is tight, keep it properly, and place it in a cool, ventilated place.